Toshiba Portege M200 Maintenance Manual page 105

3.2 Executing the Diagnostic Test
Select the option you want to execute on the test menu and press Enter. When you select 1-
SYSTEM TEST, the following message will appear:
SYSTEM TEST
SUB-TEST : XX
PASS COUNT: XXXXX
WRITE DATA: XX
ADDRESS : XXXXXX
SUB-TEST MENU :
01 - ROM checksum
02 – Dock/Undock
03 -
04 – Fan ON/OFF
05 - Geyserville
06 - Quick charge
07 - DMI read
08 - DMI write
09 -
10 – Calibration
11 –
12 – Second FAN ON/OFF
99 - Exit to DIAGNOSTIC TEST MENU
NOTE: The menu displayed on your computer may be slightly different from the one
shown above.
Select the subtest number to execute from the subtest menu and press Enter. The following
message will appear:
TEST LOOP
ERROR STOP : YES (or NO)
Use the right and left arrow keys to move the cursor to the desired option.
Selecting YES in TEST LOOP increases the pass counter by one each time the test cycle ends,
and restarts the test cycle.
Selecting NO in TEST LOOP terminates the test and returns to the subtest menu after one test
cycle is complete.
Portege M200 Maintenance Manual (960-457)
XXXXXXX XXXX DIAGNOSTIC TEST VXXX
[Ctrl]+[Break] : test end
[Ctrl]+[C]
ERROR COUNT: XXXXX
READ DATA
STATUS
: YES (or NO)
3 Tests and Diagnostics
: key stop
: XX
: XXX
3-5