Lcd Unit/Fl Inverter - Toshiba Portege M200 Maintenance Manual

4.19 LCD unit/FL inverter

4.19 LCD unit/FL inverter
Removing the LCD unit and FL inverter
The following describes the procedure for removing the LCD unit and FL inverter. (See
Figure 4-31 to 4-34.)
NOTE: When removing the LCD unit or FL inverter, do not press the LCD part of the
base cover assembly. It may cause the breakage of the hinge assembly.
Use a stand or something to make the LCD part flat for installing the LCD
unit and FL inverter, and to make the base assembly floating from the ground.
1. Remove the four mask cushions from the LCD cover by using a needle.
Remove the two mask seals from the display mask.
2. Remove the following screws securing the LCD cover.
•
M2.5×6B FLAT BIND screw
3. Open the display until LCD and the base assembly become horizontal. Insert your
nails into slit of the LCD and release the latches from the bottom side of the LCD.
6
Mask seal
Portege M200 Maintenance Manual (960-457)
6
6
6
6
Figure 4-31 Removing the LCD mask
4 Replacement Procedures
x6 (Described as 6 in the figure)
Slit for releasing the latches
6
Mask cushion
4-43