Touch Pad - Toshiba Portege M200 Maintenance Manual

4 Replacement Procedures
4.5

Touch pad

Removing the touch pad
The following describes the procedure for removing the touch pad. (See Figure 4-5.)
1. Disconnect the flat cable from the connector on the system board.
2. Pull the touch pad holder slantwise from the compu ter.
3. Remove the following screws securing the touch pad.
• M2.5×3B S-THIN screw
4. Remove the touch pad from the computer.
5. Disconnect the flat cable from the touch pad.
Touch Pad
Installing the touch pad
The following describes the procedure for installing the touch pad (See Figure 4-5.).
1. Connect the flat cable to the touch pad.
2. Install the touch pad on the computer.
3. Secure the touch pad with the following screws.
• M2.5×3B S-THIN screw
4. Insert the touch pad holder into the touch pad slot slantwise.
5. Connect the flat cable to the connector PJ3240 on the system board.
4-14
Figure 4-5 Removing the Touch Pad
x2
Touch Pad Holder
M2.5x3B S-THIN
x2
Portege M200 Maintenance Manual (960 -457)
4.5 Touch pad