Toshiba Portege M200 Maintenance Manual page 226

4.16 Speaker/LED board
4.16.2 LED board
Removing the LED board
The following describes the procedure for removing the LED board. (See Figure 4-26.)
1. Remove the following screws securing the LED board and remove LED lens
holder.
• M2.5×2.8B
2. Disconnect the flat cable from the LED board.
3. Remove the LED board from the LED lens holder.
LED board
LED lens holder
Installing the LED board
The following describes the procedure for installing the LED board. (See Figure 4-26.)
1. Install the LED board to the LED lens holder.
2. Connect the flat cable to the LED board and system board.
3. Install the LED lens holder to the base assembly and secure it with the following
screws.
• M2.5×2.8B
Portege M200 Maintenance Manual (960-457)
FLAT BIND screw
Flat cable
Figure 4-26 Removing the LED board
FLAT BIND screw
4 Replacement Procedures
x1
M2.5x2.8B FLAT BIND
x1
4-37