Table of Contents
Advertisement
●
Connect a Category 5 cable from the NET MGT network management port to
your network switch or hub.
FIGURE:
Related Information
"Connect the Service Processor Serial Management Port" on page 35
■
"Connect the Ethernet Network Cables" on page 37
■
▼ Connect the Ethernet Network Cables
1. Connect a Category 5 cable from your network switch or hub to Ethernet Port 0
(NET0) on the rear of the chassis.
NET0 is the farthest left port in the 4-port network cluster.
2. Connect Category 5 cables from your network switch or hub to the remaining
Ethernet ports (NET1, NET2, NET3), as needed.
36
Sun SPARC Enterprise T5140 and T5240 Servers Installation Guide • December 2010
Service Processor Network Management Port – Rear Panel
Advertisement
Table of Contents
