Connect Ethernet Network Cables - Oracle SPARC T7-2 Installation Manual

Connect Ethernet Network Cables

Connect a Category 5 (or better) cable from the NET MGT port to your network
switch or hub.
Related Information
"Connect Ethernet Network Cables" on page 50
■
"Assign a Static IP Address to the NET MGT Port" on page 66
■
"Connect the SER MGT Cable" on page 48
■
Connect Ethernet Network Cables
The server has four Gigabit Ethernet network connectors, marked NET0, NET1, NET2,
and NET3. Use these ports to connect the server to the network. The Ethernet interfaces
operate at 100 Mbps, 1000 Mbps, and 10000 Mbps. See,
Cables" on page
Note -
of these Ethernet ports. Refer to the Administration Guide for your server for instructions.
Note -
that support 1000BASE-T networks.
50 SPARC T7-2 Server Installation Guide • March 2016
50.
The Oracle ILOM sideband management feature enables you to access the SP using one
To achieve 1-GbE network speeds, use Category 6 (or better) cables and network devices
"Connect Ethernet Network