Enable The Service Processor Network Management Port - Oracle Sun SPARC Enterprise T5140 Installation Manual

Time Zone
Date and Time
root Password
11. Log in to the server and explore its capabilities.
There are many commands you can use to verify the functionality of the system.
The following list describes a few of them:
■
■
■
Review the Solaris OS man pages and documentation for more details.
Related Information
"Enable the Service Processor Network Management Port" on page 47
■
■ Solaris Documentation
Sun SPARC Enterprise T5140 and T5240 Servers Administration Guide.
■
Enable the Service Processor Network
Management Port
The service processor network management port is not operational unless your
network employs DHCP, in which case the configuration in automatic. If your
network uses DHCP, you can run this command to view your server's network
configuration information:
-> show /SP/network
For example,
-> show /SP/network
/SP/network
Select the time zone.
Accept the default date and time or change the values.
Enter the root password twice. This password is for the superuser account for the
Solaris OS on this server. This password is not the SP password.
showrev – Displays the hostname and system architecture information. Use
the -a option with this command to see the patches that are installed.
psrinfo – Displays information about the number and status of the processors
and cores in the host.
prtdiag – Displays system configuration and diagnostic information.
Targets:
Powering On the System 47