FIGURE:
6. Feed the exposed section of the appropriate wire into the round plug hole in the
DC input plug.
FIGURE:
Figure Legend
Note – If you need to remove a wire from the DC input plug, insert the cage clamp
operating tool or a small screwdriver into the slot directly above the wire and push
in. Pull the wire from the DC input plug.
98
Sun SPARC Enterprise T5140 and T5240 Servers Installation Guide • December 2010
Opening the Cage Clamp Using the Cage Clamp Tool
Connector Wiring Assignments
1
From -48V or -60V
2
From Chassis ground (green/yellow)
3
From -48V or -60V Return