Table of Contents
Advertisement
The front, middle, and rear sections form the slide rail. The middle and rear sections
■
have holes for mounting screws, and adjust to fit rack depths from 24 in. (61 cm)
to 36.5 in. (93 cm). The front section can be extended to allow movement of the
server out of the rack.
The removable mounting bracket slides 14 in. (35.5 cm) out of the slide rail, then
■
locks in place. If you unlock the mounting bracket at this point, it slides an
additional 12 in. (30 cm) before separating from the slide rail. You can then mount
the mounting bracket to the right or left side of the server chassis.
There are a total of five locks in a slide rail assembly. Four are on the mounting
■
bracket. One lock is on the front section of the slide rail.
a Rack" on page 19
16
Sun SPARC Enterprise T5140 and T5240 Servers Installation Guide • December 2010
describes the uses of these locks.
"Installing the Servers in
Advertisement
Table of Contents
Need help?
Do you have a question about the Sun SPARC Enterprise T5140 and is the answer not in the manual?