Logging Into The Service Processor; Log Into The Service Processor Using The Serial Management Port - Oracle Sun SPARC Enterprise T5140 Installation Manual

Logging Into the Service Processor

If you are powering on the system for the first time after installation, use the service
processor serial port to power on the system and run POST. See
Processor Using the Serial Management Port" on page
If the network management port has already been configured, you can use it instead
of the serial management port.
This section contains the following topics:
"Log Into the Service Processor Using the Serial Management Port" on page 49
■
"Configure the Service Processor Network Management Port" on page 50
■
"Log Into the Service Processor Using the Network Management Port" on page 53
■
▼ Log Into the Service Processor Using the Serial
Management Port
After the service processor boots, access the ILOM CLI to configure and manage the
system. The ILOM CLI prompt (->) is displayed at the first time the service processor
is booted. The default configuration provides an ILOM CLI root user account. The
default root password is changeme. Change the password using the service
processor ILOM CLI password command.
1. If this is the first time the system has been powered on, use the password
command to change the root password.
...
Starting OpenBSD Secure Shell server: sshd.
Starting Servicetags listener: stlistener.
Starting FRU update program: frutool.
hostname login: root
Password: changeme
Copyright 2007 Sun Microsystems, Inc. All rights reserved.
Use is subject to license terms.
...
Federal Acquisitions: Commercial Software -- Government Users
Subject to Standard License Terms and Conditions.
...
Warning: password is set to factory default.
"Log Into the Service
49.
Powering On the System 49