Log Into The Service Processor Using The Network Management Port - Oracle Sun SPARC Enterprise T5140 Installation Manual

Note – After setting the configuration parameters, you must enter the set
/SP/network commitpending=true command for the new values to take affect.
3. Commit the changes to the service processor network parameters.
-> set /SP/network commitpending=true
Set 'commitpending' to 'true'
Note – You can type the show /SP/network command again (after performing the
set /SP/network commitpending=true command) to verify that the
parameters have been updated.
Related Information
"Configure the Service Processor Network Management Port" on page 50
■
Sun SPARC Enterprise T5140 and T5240 Servers Administration Guide
■
▼ Log Into the Service Processor Using the
Network Management Port
Note – You must configure the service processor parameters shown in
the Service Processor Network Management Port" on page 50
network management port.
●
Open an SSH session and connect to the service processor by specifying its
network address.
% ssh root@xx.xxx.xx.x
...
Are you sure you want to continue connecting (yes/no)? yes
...
Password: password (nothing displayed)
Waiting for daemons to initialize...
Daemons ready
Integrated Lights Out Manager
Version 3.0.0.0
"Configure
before you can use the
Powering On the System 53