Table of Contents
Advertisement
Create Array
1
Select Toolkit from the Main menu, press the <3> key and press <Enter>.
2
Choose Show Drives by pressing the <3> key and press <Enter>.
MESSAGE:
OPTIONS:
1
1 Show Drives
2 Drive Information
3 Change Drive State
ENTER PARAMETER:
INSTRUCTIONS:
Press any key to continue
Chan #0: Status ONL ONL ONL ENV ONL - - - - - - - - - -
Chan #1: Status ONL ONL SBY ENV SBY - - - - - - - - - -
SDRV#
NOTE:
Make a note of the drives and their locations. You will need this
information during the Create Array function.
Drive numbering is: 0, 1, 2, 3, 4, 5, 6, 7, 8, 9, a, b, c, d, e, and f.
Select Configuration from the Main menu, press the <1> key and press
3
<Enter>.
4
Select Create Array from the Configuration menu, press the <3> key and
press <Enter>.
5
Select the drive channel that contains the drive you want to add to the array
and press <Enter>. The system will prompt for the Target ID.
6
Select the SCSI ID of the drive you want to add and press <Enter>.
7
Repeat the channel and drive selection steps (5 and 6) for each drive. The
display adds each drive to the screen as it is selected.
-
-
-
-
-
Configuration
- - - - - - - - - -
Configuring the Array
71
Advertisement
Table of Contents
