Table of Contents
Advertisement
Configuration
NOTE:
68
Configuring the Controllers Parameters
MESSAGE:
OPTIONS:
1 Format Drives
2 Controller Parameters
3 Controller Diagnostics
INSTRUCTIONS:
Press Space bar to change. Esc to Continue. <Enter> for next parameter.
INFORMATION:
Automatic Rebuild Management: Enabled
For detailed information about each option, refer to "Option 2 - New
Configuration" on page 52.
a
Set "Automatic Rebuild Management" to Enabled.
b
Set "Operational Fault Management" to Enabled.
Set "Controller Read Ahead" to Enabled.
c
Set "Super Read Ahead" to Disabled.
d
e
Set "Command Tagging, Channel #0" to Enabled.
f
Set "Command Tagging, Channel #1" to Enabled.
g
Set "Force 8-bit SCSI, Channel #0" to Disabled.
h
Set "Force 8-bit SCSI, Channel #1" to Disabled.
Set "Conservative Cache Mode" to Disabled.
i
Set "Force Simplex Mode" to Enabled.
j
k
Set "Installation Abort" to Disabled.
l
Set "Broad Reassign Mode" to Disabled.
m Set "Controller Present/Fault Signals" to Disabled.
n
Set "Automatic Failback" to Disabled.
Advertisement
Table of Contents
