Table of Contents
Advertisement
2
Installation
The setup of your nStor Ultra S2S RAID Controller consists of installing the
controller and the feature card, setting any required jumpers, connecting the
cables, and configuring the array.
Be sure to read the manual prior to proceeding with the installation. There are
several possible configurations in which different feature cards, jumper settings,
and cabling are required.
NOTE:
Shielded I/O cables, such as those provided with the subsystem, must be
used to prevent radio frequency interference.
You will need to reference several manuals during the installation. They are the
CR8e User's Guide, the Feature Card User's Guide, and the Battery Backup
Module flyer (optional).
Supported Application
There are three types of installation covered in this user's guide. They include:
Simplex – a CR8e with an Ultra S2S RAID Controller connected to a single
host.
Duplex (Dual-Active)– two CR8e's each with an Ultra S2S RAID
Controller connected to one host system.
Clustering (Dual Host Failover/Failback) – one CR8e with an Ultra S2S
RAID Controller connected to two host systems.
17
Advertisement
Table of Contents
