Table of Contents
Advertisement
Set "Simplex No Reset" to Enabled.
o
Set "SCSI Transfer rate, Channel #0" to 20 MB/s.
p
q
Set "SCSI Transfer rate, Channel #1" to 20 MB/s.
r
Set "Spinup option" to Automatic.
s
Set "Number of disks per spin" to 2.
t
Set "Spin-up initial delay (seconds)" to 12.
Set "Spin-up sequence delay (seconds)" to 24.
u
Set "Stripe size in KB=" to 16.
v
w Set "Logical Block Size in Bytes" to 512.
x
Set "Rebuild rate" to 50.
y
Set "Serial Channel A" to SLP/VT100.
z
Set "Controller Present/Fault Selection" to A.
aa Set "Host Bus Reset Delay (0=OFF)" to 0.
MESSAGE:
OPTIONS:
1 Format Drives
2 Controller Parameters
3 Controller Diagnostics
INSTRUCTIONS:
Press Space bar to change. Esc to Continue. <Enter> for next parameter.
INFORMATION:
Enter "Y" to save changes.
Press <Y> to save changes.
4
5
Press <Esc> to return to the Main menu.
Configuration
Configuring the Controllers Parameters
69
Advertisement
Table of Contents
