Table of Contents
Advertisement
Installation
5
6
7
8
9
10 Set the SCSI IDs. The IDs are configured via the Operator Control Panel
11 After setting the subsystem identification you must power cycle the
12 Proceed with completing the installation by configuring the array, refer to
34
Duplex (Dual-Active) Configuration
Connect a one (1) meter data cable from the Master cabinet Ch #0 I/O
Interface card to the Slave #1 cabinet Ch #0 Ultra Extender card connectors.
Secure the cable connectors using the thumb screws.
Connect a one (1) meter data cable from the Master cabinet Ch #1 I/O
Interface card to the Slave #1 cabinet Ch #1 Ultra Extender card connectors.
Secure the cable connectors using the thumb screws.
Repeat steps 5 and 6 for the second set of slave cabinets connected to the
second master cabinet.
Connect one end of the S2S Cluster cable to the S2S Feature card at the Serial
B connector on the Master #1 subsystem using the RJ11 connector plug.
Connect the other end to the Master #2 subsystem S2S Feature card to the
Serial B connector.
Turn on the power to the CR8e's. After the power-on self-test has successfully
completed, the Status and Channel Mode LEDs will be solid green.
using the predefined sets. Access the Options menu and select "SAFTE
CHAIN ID" then choose "Master" for the subsystem identified as the master
#1 subsystem and "Slave 1" for the subsystem identified as the first slave
subsystem and "Slave 2" for the second slave subsystem. Use the same
settings for the master #2 and its first and second slave subsystems.
subsystems. Observe normal power cycling precautions by waiting a minimum
of five (5) seconds before applying power again.
Chapter 3 Configuration.
Advertisement
Table of Contents
