Manual Adjust/Automatic Adjust - FLIR ThermaCAM EX320 User Manual

10 – Camera program
Label
Alarm
Alarm output
Delta alarm
Ref temp
Alarm temp
10
10.4.3
Point to Manual adjust and press MENU/YES to manually select level and span set-
tings. The level command can be regarded as the brightness, while the span command
can be regarded as the contrast.
Press the navigation pad up/down to change the level (indicated by an arrow
■
pointing upwards or downwards in the temperature scale)
Press the navigation pad left/right to change the span (indicated by two arrows
■
pointing away from each other or towards each other)
70
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
FAX 781.665.0780 - TestEquipmentDepot.com
Value
Off
■
Above
■
Below
■
Color only
■
Silent
■
Beep
■
N/A
User-defined
User-defined

Manual adjust/Automatic adjust

Explanation
Select Off to disable the alarm
■
Select Above to assign an alarm color to all
■
pixels above the alarm temperature
Select Below to assign an alarm color to all
■
pixels below the alarm temperature
Select Color only to assign only a color to the
■
pixels when an alarm is triggered.
Select Silent to additionally make the font of
■
the temperature result increase in size and be
displayed against a red background (i.e. a visu-
al alarm)
Select Beep to additionally make the camera
■
trigger a beep when an alarm is triggered.
Enter an delta alarm value by pressing the naviga-
tion pad left/right.
➲ This label is only available if Update ref temp
has been previously selected in the Settings dialog
box.
For information purposes only.
The reference temperature is calculated and updat-
ed 'on the fly'.
➲ This label is only available if Update ref temp
has been previously selected in the Settings dialog
box.
Enter a temperature value by pressing the naviga-
tion pad left/right.
Publ. No. 1558146 Rev. a156 – ENGLISH (EN) – February 28, 2006