Table of Contents
Advertisement
8.2
Input of nominal value and tolerance limits, function start
F
The
Input function selection is carried out as described in chapter 6.4.
8.2.1 Weighed nominal value and tolerances
F
The
Note: See chapters 6.2 – 6.4 for assignment of the function key
F
F
Start weighing
F
Start weighing
The tolerance check is started after the To has been measured
The green pilot lamp indicates the result of the weight evaluation. Further weights can now
be checked. Nominal value and tolerance limits are maintained until the function is
switched off using the
FIS-BA-def-0411
key is assigned to a tolerance check input function.
key is assigned to
F
key.
A nominal weight of 2.000 kg is
on the balance
Start the tolerance check
function.
The nominal weight is weighed
on start-up of the function.
Weigh the lower Tu tolerance.
Apply a Tu weight of 1.800 kg
The weight value is indicated
The value for Tu has been
adopted.
Weigh the upper To tolerance
A To weight of 2.100 kg has
been applied
The value for To has been
adopted
87
Advertisement
Table of Contents
