Mode „Percent; Input Of The 100%-Reference Weight By Weighing - KERN 470 Series Operating Instructions Manual

Tare cups can also be used when counting parts. Before starting tare it with TARE.
Leave the parts counting program by pressing F. Release it
when 1 SEt 2
Further see point 11 „General programmations".
The last memorised reference number is kept even when the „parts counting" program
will be left.
Parts counting with tolerance range, see point 8.
Accumulation of numbers of pieces, see point 9.
6.3 Mode „percent"
Any weight can be memorised as a reference weight 100 %. All deviations of this
weight will be indicated in %.
Example: Reference weight prior to drying 100 g,
after drying 80 g
Indication either 80 % absolute
or after taring 20 % relative.
Set mode „percent" with F and TARE on
programmations".
Confirm with S.
Important!
The higher the reference weight 100 %
the more decimal places.

6.3.1 Input of the 100%-reference weight by weighing.

Press F and release it when P SEt
Now flashing display of the actually memorised reference weight corresponding to 100
%.
Place new 100 % reference weight on the weighing plate.
Confirm with F, the memorising will need a short time. Now
Now the balance displays each deviation from the 100 % reference weight in %
absolute.
By taring after having memorised the reference weight 100 % the balance will display
in % relative.
40
appears.
appears.
1 SET 3 See point 10 „ General
100, ..... % appears.
Func an then
470-BA-defs-0017