Separating Transmission Case - Kubota L3200 Workshop Manual

L3200, WSM

(3) Separating Transmission Case

Draining the Transmission Fluid
1. Place an oil pan underneath the transmission case.
2. Remove the drain plugs (1) at the bottom of the transmission
case.
3. Drain the transmission fluid.
4. Screw in the drain plugs (1).
(When reassembling)
• Full up new oil to the upper line of the gauge (2) from the filling
port after removing the filling plug (3).
• After running the engine for a few minutes, stop it and check the
fluid level again, if low, add oil to the prescribed level (A).
IMPORTANT
• Use only multi-grade transmission fluid. Use of other fluids
may damage the transmission or hydraulic system.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-6.)
• Never work the tractor immediately after changing the
transmission fluid. Keeping the engine at medium speed for
a few minutes to prevent damage to the transmission.
• Do not mix different brands oil together.
Transmission fluid Capacity
(1) Drain Plug
(2) Gauge
(3) Filling Plug
3-S11
TRANSMISSION
27.5 L
7.3 U.S.qts
6.1 Imp.qts
A : Oil level is acceptable within this
range.
W1028669
KiSC issued 12, 2006 A