Kubota L3200 Workshop Manual page 161

L3200, WSM
Propeller Shaft
1. Remove the screw (3) then tap out the spring pin (5).
2. Slide the propeller shaft cover 1 (8) to the front and the cover 2
(2) to the rear.
3. Tap out the spring pins (1) and then slide the coupling (6) to the
front and coupling (4) to the rear.
(When reassembling)
• Apply grease to the splines of the propeller shaft (7) and pinion
shaft.
(1) Spring Pin
(2) Propeller Shaft Cover 2
(3) Screw
(4) Coupling
Separating Engine from Clutch Housing Case
1. Check the engine and clutch housing case are securely mounted
on the disassembling stands.
2. Remove the engine mounting screws, and separate the engine
from the clutch housing case.
(When reassembling)
• Apply grease to the splines.
• Apply liquid gasket (Three Bond 1208D or equivalent) to joint
face of the engine and clutch housing case.
Engine mounting screws to
Tightening torque
clutch housing
3-S9
TRANSMISSION
(5) Spring Pin
(6) Coupling
(7) Propeller Shaft
(8) Propeller Shaft Cover 1
W1066505
48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
W1067100
KiSC issued 12, 2006 A