Check Points Of Initial 50 Hours - Kubota L3200 Workshop Manual

L3200, WSM

[2] CHECK POINTS OF INITIAL 50 HOURS

Changing Engine Oil
CAUTION
• Before changing oil, be sure to stop the engine.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To drain the used oil, remove the drain plug (1) at the bottom of
the engine and drain the oil completely.
4. Screw in the drain plug (1).
5. Fill new oil up to upper hole on the dipstick (3).
IMPORTANT
• When using an oil of different manufacture or viscosity from
the previous one, remove all of the old oil.
• Never mix two different types of oil.
• Use the proper SAE Engine Oil according to ambient
temperatures.
• Refer to "LUBRICANTS, FUEL AND COOLANT". (See page
G-7).
Engine oil Capacity
(1) Drain Plug
(2) Oil Inlet Plug
(3) Dipstick
Replacing Engine Oil Filter Cartridge
CAUTION
• Be sure to stop the engine before changing oil filter
cartridge (1).
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the engine oil filter cartridge (1).
2. Put a film of clean engine oil on rubber seal of new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the dipstick.
Then, replenish the engine oil up to the prescribed level.
IMPORTANT
• To prevent serious damage to the engine, replacement
element must be highly efficient.
genuine filter.
(1) Engine Oil Filter Cartridge
G-11
G GENERAL
5.7 L
6.0 U.S.qts
5.0 lmp.qts
(A) Oil lever is acceptable within this
range.
W1014533
Use only a KUBOTA
W1026738
KiSC issued 12, 2006 A