Kubota L3200 Workshop Manual page 158

L3200, WSM
Bonnet and Front Cover
1. Disconnect the battery negative cable (1).
2. Disconnect the connector to head light and the head light wiring.
3. Remove bonnet (2) and side covers (3) on both sides.
4. Remove the front cover (4).
(1) Battery Negative Cable
(2) Bonnet
Steering Wheel and Rear Bonnet
1. Disconnect the connector to front position lamps and remove the
front position lamp supports (5) on both sides.
2. Remove the steering wheel (1) with steering puller.
3. Remove the throttle grip (2).
4. Disconnect the hour-meter cable from the engine.
5. Remove the meter panel (3).
6. Disconnect the 5P connector (6) to position light switch.
7. Disconnect the 4P connector (7) to hazard light switch.
8. Disconnect the 4P connector (8) to main switch.
9. Disconnect the 8P connector (9) to combination switch.
10.Remove the rear bonnet (4).
(When reassembling)
Steering wheel mounting
Tightening torque
nut
(1) Steering Wheel
(2) Throttle Grip
(3) Meter Panel
(4) Rear Bonnet
(5) Front Position Lamp Support
3-S6
TRANSMISSION
(3) Side Cover
(4) Front Cover
W1022852
29.4 to 49.0 N·m
3.0 to 5.0 kgf·m
21.7 to 36.2 ft-lbs
(6) 5P Connector
(7) 4P Connector
(8) 4P Connector
(9) 8P Connector
W1064593
KiSC issued 12, 2006 A