Disassembling Differential Gear Assembly - Kubota L3200 Workshop Manual

L3200, WSM

(3) Disassembling Differential Gear Assembly

Front Drive Case
1. Removing the front drive case.
2. Remove the oil seal (1).
3. Tap out the propeller shaft 1 (3) to the front.
4. Take out the shift gear (6).
(When reassembling)
• Replace the oil seal (1) with a new one and apply grease to its
inside.
• Apply liquid gasket (Three Bond 1208D, 1141 or equivalent) to
both faces of the gasket that is to be installed between the front
drive case and the transmission case.
(1) Oil Seal
(2) Ball Bearing
(3) Propeller Shaft 1
(4) Balls
(5) Spring
Bearing and Differential Lock Shifter
1. Secure the differential gear in a vise.
2. Remove the differential lock shifter and taper roller bearing as a
unit with a puller.
Differential Case Cover and Differential Side Gear
1. Remove the differential case cover (3).
2. Remove the differential side gear (1) and differential side gear
washer (2).
(When reassembling)
• Apply molybdenum disulfide (Three Bond 1901 or equivalent) to
the inner circumferential surface of the differential side gear boss.
Differential case cover
Tightening torque
mounting screw
(1) Differential Side Gear
(2) Differential Side Gear Washer
3-S26
TRANSMISSION
(6) Shift Gear
(7) Ball Bearing
(8) Shift Lever
(9) O-ring
W1029570
W14789652
48.1 to 55.8 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
(3) Differential Case Cover
W10247220
KiSC issued 12, 2006 A