Kubota L3200 Workshop Manual page 223

L3200, WSM
Bumper and Tie-rods
1. Place the disassembling stand under the transmission case.
2. Remove the bumper.
3. Remove the tie-rods with the tie-rod end lifter.
In this case, take special care not to damage the tie-rod end nut
(slotted nut). (It is preferable to replace it with an unrequired nut.)
4. Reinstall the bumper.
(When reassembling)
Tightening torque Tie-rod end nut
IMPORTANT
• After tightening the tie-rod end nut to the specified torque,
install a cotter pin as shown in the figure left.
Breather Pipe
1. Remove the breather pipe (1).
(1) Breather Pipe
Front Axle
1. Place the disassembling stand under the front axle, and hang up
the front bumper by the hoist to support it.
2. Remove the shaft bracket 1 mounting screws and shaft bracket
2 mounting screws.
3. Separate the front axle from the front axle support.
4. Remove the front wheels.
(When reassembling)
Shaft bracket 1 (front)
mounting screws
Shaft bracket 2 (rear)
mounting screws
Tightening torque
Front wheel mounting lug
nuts
Front wheel mounting stud
bolts
6-S9
FRONT AXLE
39.2 to 44.1 N·m
4.0 to 4.5 kgf·m
28.9 to 32.5 ft-lbs
W1013537
W1031703
240 to 260 N·m
24 to 26 kgf·m
173 to 188 ft-lbs
77.4 to 90.2 N·m
7.9 to 9.2 kgf·m
57.2 to 66.5 ft-lbs
137.3 N·m
14.0 kgf·m
101.3 ft-lbs
63.7 to 73.5 N·m
6.5 to 7.5 kgf·m
47.0 to 54.2 ft-lbs
W1013808
KiSC issued 12, 2006 A