Kubota L3200 Workshop Manual page 207

L3200, WSM
Rear Axle Case
1. Loosen and remove the rear axle case mounting screws and
nuts.
2. Support the rear axle case (1) with the nylon lift strap and hoist.
3. Separate the rear axle case from brake case.
4. Follow the same procedure as above for the other side.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D, 1141 or equivalent) to
joint face of the rear axle case and brake case, after eliminating
the water, oil and the old remaining liquid gasket.
Rear axle case mounting
screw and nut
Tightening torque
Rear axle case mounting
stud bolt
(1) Rear Axle Case
Brake Case
1. Remove brake cam lever spring (3).
2. Remove suction pipe (4).
3. Remove brake rod (5).
4. Remove parking brake link (6).
5. Loosen and remove brake case mounting screw and nuts.
6. Separate the brake case (1), tapping the brake cam lever (2).
(When reassembling)
• Apply grease to the brake ball seats.
excessively.)
• Apply liquid gasket (Three Bond 1208D, 1141 or equivalent) to
joint face of the brake case and transmission case, after
eliminating the water, oil and the old remaining liquid gasket.
• Before installing the brake case to the transmission case, install
the cam plate around the four protrusions on the differential
bearing case.
• Apply liquid lock (Three Bond 1324 or equivalent) to the stud
bolts.
Brake case mounting stud
Tightening torque
bolt
(1) Brake Case
(2) Brake Cam Lever
(3) Brake Cam Lever Spring
(4) Suction Pipe
(5) Brake Rod
5-S7
BRAKES
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
24.5 to 31.4 N·m
2.5 to 3.2 kgf·m
18.1 to 23.1 ft-lbs
W1014856
(Do not grease
34.3 to 49.0 N·m
3.5 to 5.0 kgf·m
25.3 to 36.1 ft-lbs
(6) Parking Brake Link
(7) Cam Plate
(8) Brake Disc
(9) Plate
W1015066
KiSC issued 12, 2006 A