Kubota L3200 Workshop Manual page 193

L3200, WSM
Rear Axle Case
1. Loosen and remove the rear axle case mounting screws and
nuts.
2. Support the rear axle case (1) with the nylon lift strap and hoist.
3. Separate the rear axle case from brake case.
4. Follow the same procedure as above for the other side.
(When reassembling)
• Apply liquid gasket (Three Bond 1208D, 1141 or equivalent) to
joint face of the rear axle case and brake case, after eliminating
the water, oil and the old remaining liquid gasket.
Rear axle case mounting
screw and nut
Tightening torque
Rear axle case mounting
stud bolt
(1) Rear Axle Case
4-S5
REAR AXLE
48.1 to 55.9 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
24.5 to 31.4 N·m
2.5 to 3.2 kgf·m
18.1 to 23.1 ft-lbs
W1015033
KiSC issued 12, 2006 A