L3200, WSM
Suction Hose and Delivery Pipe
1. Disconnect the suction hose (2).
2. Remove the step (6) mounting screws.
3. Remove the steering joint shaft (3).
4. Remove the delivery pipe (5).
5. Remove the throttle rod (1).
(When reassembling)
• Lift the universal joint so that there should be a clearance (A) of
more than 5 mm (0.19 in.) between the universal joint and
flywheel housing.
Then fit the support (4) in position.
Tightening torque
Delivery pipe joint bolt
(1) Throttle Rod
(2) Suction Hose
(3) Steering Joint Shaft
Wiring Harnesses (Left Side)
1. Disconnect 1P battery connector (1) and remove slow below fuse
boxes (8).
2. Disconnect horn terminals (2).
3. Disconnect 13P connector to flasher unit (3).
4. Disconnect alternator wring harness (7).
5. Disconnect starter motor wiring harness (6).
6. Disconnect 1P connector to engine oil pressure switch (5).
7. Put aside main wiring harness (4).
(1) 1P Battery Connector
(2) Horn Terminals
(3) 13P Connector
(4) Main Wiring Harness
1-S21
ENGINE
49 to 69 N·m
5.0 to 7.0 kgf·m
36.1 to 50.6 ft-lbs
(4) Support
(5) Delivery Pipe
(6) Step
W1065019
(5) 1P Connector
(6) Starter Motor Wiring Harness
(7) Alternator Wiring Harness
(8) Slow Blow Hose Boxes
W1065603
KiSC issued 12, 2006 A