Kubota L3200 Workshop Manual page 316

L3200, WSM
Rotor
1. Press out the rotor (1) from drive end frame (3).
IMPORTANT
• Take special care not to drop the rotor and damage the slip
ring or fan, etc..
(1) Rotor
(2) Block
Retainer Plate
1. Unscrew the four screws holding the retainer plate, and remove
the retainer plate (1).
(1) Retainer Plate
Bearing on Drive End Side
1. Press out the bearing from drive end frame (3) with a press and
jig (1).
(1) Jig
(2) Block
Bearing at Slip Ring Side
1. Lightly secure the rotor (1) with a vise to prevent damage, and
remove the bearing (2) with a puller (3).
(1) Rotor
(2) Bearing
9-S25
ELECTRICAL SYSTEM
(3) Drive End Frame
W10194380
W10195420
(3) Drive End Frame
W10196110
(3) Puller
W10197010
KiSC issued 12, 2006 A