Kubota L3200 Workshop Manual page 247

L3200, WSM
Valve Assembly
1. Remove the valve mounting screws.
2. Remove the valve assembly (1) and ball nut (2).
(When reassembling)
• Apply oil to O-ring and oil seal.
Tightening torque Valve mounting screw
(1) Valve Assembly
Ball Nut Assembly
1. Remove the lock nut (1).
2. Take out the ball nut assembly (2).
(When reassembling)
• Apply oil to sleeve.
Tightening torque Lock nut
(1) Lock Nut
Relief Valve
1. Loosen the lock nut (5) and remove the adjusting screw (4).
2. Take out the spring (2) and poppet (1).
(When reassembling)
• Apply grease to O-ring (3).
• Be sure to adjust the relief valve pressure. (See page 8-S8.)
Tightening torque Lock nut
(1) Poppet
(2) Spring
(3) O-ring
7-S8
STEERING
48.0 to 55.0 N·m
4.9 to 5.7 kgf·m
35.4 to 41.2 ft-lbs
(2) Ball Nut
W10157020
88.3 to 107.9 N·m
9.0 to 11.1 kgf·m
65.1 to 80.3 ft-lbs
(2) Ball Nut Assembly
W10277980
49.1 to78.5 N·m
5.0 to 8.0 kgf·m
36.2 to 57.9 ft-lbs
(4) Adjusting Screw
(5) Lock Nut
W1016158
KiSC issued 12, 2006 A