Preparation; Separating Steering Gear Box - Kubota L3200 Workshop Manual

L3200, WSM

[2] PREPARATION

(1) Separating Steering Gear Box

Joint Shaft
1. Remove the support (3) mounting screw.
2. Remove the screw (1).
3. Remove the joint shaft (2).
(When reassembling)
• Lift the universal joint so that there is a clearance (A) of more than
5 mm (0.19 in.) between the universal joint and flywheel housing.
Then fit the support (3) is position.
(1) Screw
(2) Joint Shaft
(3) Support
Bumper and Tie-rods
1. Place the disassembling stand under the transmission case.
2. Remove the bumper.
3. Remove the tie-rods with the tie-rod end lifter.
In this case, take special care not to damage the tie-rod end nut
(slotted nut). (It is preferable to replace it with an unrequired nut.)
4. Reinstall the bumper.
(When reassembling)
Tightening torque Tie-rod end nut
IMPORTANT
• After tightening the tie-rod end nut to the specified torque,
install a cotter pin as shown in the figure left.
7-S5
STEERING
(A) Clearance
W1025827
39.2 to 44.1 N·m
4.0 to 4.5 kgf·m
28.9 to 32.5 ft-lbs
W1015206
KiSC issued 12, 2006 A