Dtc 11: A Problem In The Mode Control Linkage, Doors, Or Motor - Honda EP3 Service Manual

Turn the ignition switch OFF, and check for
continuity between the following terminals of
heater control panel connectors A (14P) and B (22P)
and the mode control motor 10P connector.
1 4 P : 1 0 P :
N o . 2 N o .
' 1 0
N o . 1 0 N o , 1
N o . 1 1 N o . 2
2 2 P : 1 0 P :
N o . 1 7 N o . 8
N o . 1 8 N o . 6 , 9
N o . 1 9 N o . 5
N o . 2 0
N o . 4 , 7
HEATER CONTROL PANEL CONNECTOR A (14PI
Wire side of lemale terminals
HEATER CONTROL PANEL CONNECTOR B {22PI
Wire side of female terminals
ls there continuity?
YES-Check for loose wires or poor connections at
heater control panel connectors A (14P) and B (22P),
and at the mode control motor 10P connector. lf the
connections are good, substitute a known-good
mode control motor, and recheck. lf the symptom/
indication goes away. replace the original mode
control motor.lf the symptom/indication continues,
substitute a known-good heater control panel, and
recheck. lf the symptom/indication goes away,
replace the original heater control panel.l
NO Repair any open in the wire(s) between the
heater control Danel and the mode control motor.l
MODE CONTROL MOTOR lOP CONNECTOR
Wire side of female terminals
DTC 11: A Problem in the Mode Control
Linkage, Doors, or Motor
1. Testthe mode control motor (see page 21-35).
ls the mode control motor OK?
YES Substitute a known-good heater control
panel, and recheck. lf the symptom/indication goes
away, replace the original heater control panel.l
NO Replace the mode control motor, or repair the
l i n k a g e a n d d o o r s . l
21-19