Honda EP3 Service Manual page 1142

t
5. Disconnect the floor wire harness 2P connector (A)
from the driver's side impact sensor.
Disconnect SRS unit connector B (18P) from the
SRS unit (see step 7 on page 23-22)
Check resistance between the No. 8 terminal of
SRS unit connector B (18P) and body ground. There
should be an open circuit, or at least 1 M Q .
1 .
I
SRS UNIT CONNECTOR B {18PI
Wire side of female te.minals
ls the resistance as specitied?
YES-Go to step 8.
NO-Short to ground in the floor wire harness;
replace the floor wire harness.I
BRN/YEL
8. Check resistance between lhe No.8 and No. l5
terminals of SRS unil connector B (18P). There
should be an open circuit, or at least 1 M 0 .
SRS UNIT CONNECTOR B {18P'
BRN/YEL
I
flliT;l n
2
3
10 11
1tr6l1tf;l \
LT GRN/RED
Wire side oI female terminals
ls the resistance as specitied?
YES-Faulty driver's side impact sensor or SRS
unit; replace the driver's side impact sensor (see
page 23-1251.lf the problem is still present, replace
t h e S R S u n i t ( s e e p a g e 2 3 - 1 2 2 1 . a
NO- Short in the floor wire harness; replace the
f l o o r w i r e h a r n e s s . I
23-93