Front Seat Belt Replacement - Honda EP3 Service Manual

Seat Belts
Front Seat Belt Replacement
SRS comDonents are located in this area. Review the
SRS component locations (see page 23-13) and the
precautions and procedures (see page 23-14) in the SRS
section before performing repairs or service,
NOTE: Check the front seat belts for damage, and
replace them if necessary. Be careful not to damage
them during removal and installation.
Front Seat Belt
Make sure you have the anti-theft code for the radio,
then write down the frequencies for the preset
buttons.
Disconnect the negative cable from the battery, and
wait at least 3 minutes before beginning work.
Slide the front seat forward fully.
Remove the lower anchor cap (A), and remove the
lower anchor bolt (B).
3 .
1 .
5 . R e m o v e t h e r e a r s i d e t r i m p a n e l ( s e e p a g e 2 0 - 5 1 ) .
23-4
qt
B
7/16-20 UNF
32 N m (3.3 kgf.m,24lbt.ft)
7. Disconnect the seat belt tensioner connector (A).
Remove the retractor mounting self-tapping ET
screw {B), and the retractor bolt (C), then remove
the front seat belt (D) and retractor (E).
6 x 1 . 0 m m
3.4 N m {0.35 kgf.m,2.5 lbf.ft)
6. Remove the upper anchor cover {A), and remove
t h e u p p e r a n c h o r b o l t ( B ) .
7/16-20 UNF
32 N.m (3.3 kgf m,2ir lbf.ft)
8. lf necessary, remove the
( F ) .
front seat belt protecto