Rear Window Wiper Motor Replacement; Washer Reservoir Replacement - Honda EP3 Service Manual

Wipers/Washers
Rear Window Wiper Motor
Replacement
1 .
B
Open the hatch, and remove the hatch trim panel
(see page 20-53).
Remove the mounting nut (A), the wiper arm (B)
and the special nut (C).
A
9.8 N.m {1.0 kgf.m,
7.2 rbf.ftl
B
8 N.m 10.8 kgt.m,
6.0 rbf.ft)
Disconnect the 4P connector {A), remove the three
mounting bolts (B), then remove the rear window
wiDer motor (C).
9.8 N.m
{1.0 kgt.m,7.2lbf ftl
4 ,
Install in the reverse order oI removal, and note
these items.
Apply multipurpose grease to the moving parts.
Before reinstalling the wiper arm, turn the wiper
switch ON, then turn OFF to return the wiper
shaft to the Dark oositon.
lf necessary, replace any damaged clips.
Check the wiDer motor operation.
22-146
-
Washer Reservoir Replacement
1 .
Partially remove the right inner fender.
Disconnect the 2P connectors (A) irom the washer
motors (B) and level switch (Canada).
3 .
Disconnecl the tubes (C) from the washer motors.
Remove the three bolts (A) and the washer
reservoir (B).
A
9.8 N.m
(1.0 kgt.m,
7.2 tbf.tt)