Rear Seat-Back Latch Replacement; Rear Seat-Back Striker Replacement - Honda EP3 Service Manual

I
Rear Seat-back Latch Replacement
1 . Remove the seat-back (see page 20-80).
Remove the seat-back cover (see page 20-82).
Remove the seat-back pad {A) from the seat-back
frame (B). On right seat-back with center shoulder
belt, pass the center belt (C) through the hole in the
seat-back pad.
Remove the bolts, then remove the seat-back latch
(A) from the seat-back frame (B), and release the
pivot pin {C) of the latch lever (D) from the seat'
back f rame.
Fastener Locations
lnstallthe latch in the reverse order of removal, and
make sure the seat-back locks and unlocks properly.
\
Rear Seat-back Striker Replacement
NOTE: Take care not to scratch the interior trim.
1 . R e m o v e t h e r e a r s i d e t r i m p a n e l ( s e e p a g e 2 0 - 5 ' l ) .
2. Remove the bolts, then remove the seat-back
striker (A).
Fastener Locations
) : Bolt, 2
F
,-;1
8 x 1.25 mm
22 N m 12.2 kgl rn,
16 tbf.ft)
3 . l n s t a l l t h e s t r i k e r i n t h e r e v e r s e o r d e r o f r e m o v a l ,
and move the striker (A) up or down until it is
centered in the seat-back latch {B).
20-81