Retraetor, Rear Center; In-Vehicle - Honda EP3 Service Manual

Seat Belts
Inspection (cont'd)
RetraEtor, Rear Center
1. Before installing the retractor, check that the seat
belt can be pulled out freely.
2, Make sure that the seat belt does not lock when the
retractor (A) is leaned slowly up to 15' from the
mounted position.
lnside
Forward
3 ,
4 .
Lean the retractor over 40', and make sure that the
seat belt does not lock when pulled out over 900
mm (35.4 in.). Do not aftempt to disassemble the
retractor.
Replace the seat belt with a new assembly if there
is any abnormality. Do not disassemble any part of
the seat belt for any reason.
23-10
\ , J
In-vehicle
1. Check that the seat belt is not twisted or caught on
anything.
2. After installing the anchors. check for free
movement on the anchor bolts. lf necessary,
remove the anchor bolts and check that the
washers and other parts are not damaged or
i m p r o p e r l y i n s t a l l e d .
3. Check the seat belts for damage or discoloration.
Clean with a shop towel if necessary. Use only
soap and water to clean.
NOTE: Dirt build-up in the loops of the upper
anchors can cause the seat belts to retract slowly.
Wipe the inside of the loops with a clean cloth
d a m p e n e d i n l s o p r o p y l a l c o h o l .
Check that the seat belt does not lock when pulled
out slowly. The seat belt is designed to lock only
during a sudden stop or impact.
For rear center shoulder belt, check that the seat
b e l t l o c k s w h e n p u l l e d o u t o v e r 4 0 0 m m ( 1 5 . 7 i n . )
with the seat-back folded down.
Make sure that the seat belt will retract
automatically when released.
For each passenger's seat belt, check the seat belt
retractor locking mechanism ALR (automatic
locking retractor). This function is for securing child
seats.
- 1 P u l l t h e s e a t b e l t a l l t h e w a y o u t t o e n g a g e t h e
ALR. The seat belt should retract with a
ratcheting sound, but not extend. This is
n o r m a l .
-2 To disengage the ALR, release the seat belt and
a l l o w i t t o f u l l y r e t r a c t , t h e n p u l l t h e s e a t b e l t
out part-way. The seat belt should retract and
extend normally.
Replace the seat belt with a new assembly if there
is any abnormality. Do not disassemble any part of
the seat belt for any reason.
7 .
8 .