Honda EP3 Service Manual page 511

Driveline/Axle
Driveshafts Reassembly (cont'dl
18. Unwind the boot band tool, and cut off the excess
free end of the bandto leave a 5- 10 mm (0.2-0.4
in.) tail protruding from the clip
19. Bend the band end (A) by tapping it down with a
n a m m e r .
NOTE;
. Make sure the band and clip do not interfere with
anything and the band does not move.
. Remove any grease remaining on the
surrounding surfaces
20. Repeat steps 12 through 19 for the band on the
other end of the boot.
1 6 - 1 4
{
2 ' 1 . I n s t a l l t h e n e w s e t r i n g .