Seat Belt Buckle - Honda EP3 Service Manual

Seat Belts
Front Seat Belt Replacement (cont'd)
Seat Belt Buckle
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the preset
buttons.
2. Disconnect the negative cable from the battery ,
and wait at least 3 minutes before beginning work.
3. Remove the front seat (see page 20-7'1).
4. Detach the seat belt switch connector clip (A), seat
belt buckle tensioner connector clip (B), and
h a r n e s s c l i p ( C ) .
5. Remove the center anchor bolt (A), and remove the
seat belt buckle {B).
7/16-20 UNF
32 N m {3.3 kgf m,24lbf.ft)
6. Pullthe seat belt switch/tensioner harness (C) out
through the hole on the seat track.
. -.. :.a--
23-6
7. Installthe buckle in the reverse order of removal,
and note these items:
. Assemble the washers on the center anchor bolt
as shown.
. Apply liquid thread lock to the center anchor bolt
before reinstallation.
. lf the seat belt tensioner has been deployed,
replace the front seat belt protector with a new
o n e .
. Apply liquid thread lock to the seat mounting
bolts before reinstallation
. Reconnect the negative cable to the battery.
. Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
. Reset the clock.
. Do the ECMiPCM idle learn procedure (see page
1 1 _ 1 3 9 ) .
COLLAR