Honda EP3 Service Manual page 1096

I
7 .
1 1 .
9 .
1 0 .
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 2-5 indicated?
YES-Go to step 9.
NO-Shon to ground in the front passenger's
airbag inflator; replace the front passenger's airbag
( s e e p a g e 2 3 - 1 1 4 ) . 1
Turn the ignition switch OFF. Disconnectthe
battery negative cable, and wait for 3 minutes.
Disconnect the driver's airbag 4P connector from
the cable reel {see step 2 on page 23-21).
Disconnect both seat belt tensioner 2P connectors
from the floor wire harness (see step 5 on page 23-
22).
I
I
I
12.
1 3 .
't 4.
Disconnect SRS unit connector A (18P) from the
SRS unit (see step 7 on page 23-221.
Disconnectthe special tool from dashboard wire
h a r n e s s B .
Check resistance between the No. 4 terminal of
SRS unit connector A (18P) and body ground, the
No. 13 terminal and body ground. the No. 5
t e r m i n a l a n d b o d y g r o u n d , a n d t h e N o . 1 4 t e r m i n a l
and body ground. There should be an open circuit,
o r a t l e a s t l M Q .
SRS UNIT CONNECTOR A {18P}
BLU/RED
BLU/YEL
Wire side ol temale terminals
ls the tesistance as specitied?
YES Faulty SRS uniu replace the SRS unit (see
page 23-122), .l
NO Short to ground in dashboard wire harness B;
r e p l a c e d a s h b o a r d w i r e h a r n e s s B . l
23-47