Dtc 2-1: Open In Front Passenger's Airbag Inflator; Dfc 2-2: Increased Resistance In Front Passenger's Airbag Inflator - Honda EP3 Service Manual

sRs
DTC Troubleshooting (cont'dl
DTC 2-1: Open in Front Passenger's Airbag
Inflator
DfC 2-2: Increased Resistance in Front
Passenger's Airbag Inflator
Special Tools Bequired
. S R S i n f l a t o r s i m u l a t o r 0 7 S A Z - T 8 4 0 1 1 A
. SRS simulator lead F 07XAZ-S230100
'1.
Erase the DTC memory {see page 23-26).
2 . T u r n t h e i g n i t i o n s w i t c h O N ( l l ) , a n d c h e c k t h a t t h e
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time,
Go to Troubleshooting Intermittent Failures (see
page 23-261.
3. Turn lhe ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector (A) from dashboard wire harness B.
07sAz-T84011A
07xAz-s230100
Connect the SRS inflator simulator (2 0
connectors) and the simulator lead F to dashboard
w i r e h a r n e s s B .
Reconnect the battery negative cable.
Erase the DTC memory.
5 .
6 .
7 .
23-42
! J
{
9 .
1 0 .
Read the DTC.
ls DTC 2-1 or DTC 2-2 indicated?
YES Go to step 9.
NO-Open or increased resistance in the front
passenger's airbag inflator; replace the front
p a s s e n g e r ' s a i r b a g { s e e p a g e 2 3 - 1 1 4 ) . I
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
Disconnect the driver's airbag 4P connector from
the cable reel (see step 2 on page 23-21],.
Disconnect both seat belt tensioner 2P connectors
from the floor wire harness (see step 5 on page 23-
22).
Disconnect SRS unit connector A (18P) from the
SRS unit (see step 7 on page 23-22). Do not
disconnect the special tool from dashboard wire
h a r n e s s B .
1 1 .
!.