Honda EP3 Service Manual page 1092

\
J
13. Check resistance between the No. 4 and No. 13
t e r m i n a l s a n d b e t w e e n t h e N o . 5 a n d N o . 1 4
t e r m i n a l s o f S R S u n i t c o n n e c t o r A ( 1 8 P ) . T h e r e
s h o u l d b e 2 . 0 3 . 0 Q .
SRS UNIT CONNECTOR A {18P)
Wire side of female terminals
ls the resistance as specified?
YES Faulty SRS unit or poor contact at SRS unit
connector A (18P). Check the connection; if the
connection is OK, replace the SRS unit (see page
23-1221.a
NO Open or increased resistance in dashboard
wire harness B; replace dashboard wire
h a r n e s s B . I
T J
23-43
DTC 2-3: Short to Another Wire or Decreased
Resistance in Front Passenger's Airbag
lnJlator
SpecialTools Required
. S R S i n f l a t o r s i m u l a t o r 0 7 S A Z - T 8 4 0 1 ' 1 A
. SRS simulator lead F 07XAZ-S230100
1 . Erase the DTC memory (see page 23-261.
2 . T u r n t h e i g n i t i o n s w i t c h O N ( l l ) , a n d c h e c k t h a t t h e
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SRS indicator stay on?
YES-Go to step 3.
NO Intermittent failu re, system is OK at this time.
Go to Troubleshooting Intermittent Failures {see
page 23-26).
3. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the front passenger's airbag 4P
connector (A) from dashboard wire harness B.
07sAz-T84011A
07xAz-s230100
C o n n e c t t h e S R S l n f l a t o r s i m u l a t o r ( 2 0
c o n n e c t o r s ) a n d t h e s i m u l a t o r l e a d F t o d a s h b o a r d
w i r e h a r n e s s B .
Reconnect the battery negative cable.
Erase the DTC memory.
(cont'd)
6 .
7 .