Stabilizer Bar Replacement - Honda EP3 Service Manual

Stabilizer Bar Replacement
1 . Raise the front of the vehicle, and support it with
safety stands in the proper location (see page 1-8).
Remove the front wheels.
Remove the self-locking nuts (A) while holding the
joint pin (B) with a hex wrench (C), and disconnect
t h e s t a b i l i z e r l i n k s ( D ) f r o m t h e s t a b i l i z e r b a r ( E ) o n
the right and left.
D
1 0 x 1 . 2 5 m m
3 9 N m
(4.0 kgf m,
29 tbl,ft)
Remove the flange bolts {A) and bushing holders
{B), then remove the bushings (C) and the stabilizer
b a r ( D ) .
FORWARD
A
1 0 x 1 . 2 5 m m
3 9 N m
(4.0 ksf.m, 29lbl.ftl
,.'i i
''i]
.
i.',.:-l
I
\' ,r' ,'
i :..
r'j-- r-'1
_: i'
i-ii::;i
;4-llt,-'j--;
4. lnstallthe stabilizer bar in the reverse order of
removal. and note these itemsl
. Use new self-locking nuts on reassembly.
. Note the right and left direction of the stabilizer
o a r .
. A l i g n t h e e n d s o f t h e p a i n t m a r k s ( A ) o n t h e
stabilizer bar with each end of the bushings (8).
. Note the forelaft direction ofthe bushing holders.
. Refer to stabilizer Link Replacement to connect
t h e s t a b i l i z e r b a r t o t h e l i n k s ( s e e p a g e 1 8 - 1 8 ) .
18-17