Honda EP3 Service Manual page 1102

t
)
6. Reconnect the battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 3-5 indicated?
YES-Go to step 9,
NO Shortto ground in the driver's seat belt
tensioner; replace the driver's seat belt
(see page 23-4).I
9. Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
10. Disconnect floor wire harness 4P connector C403
(A)from dashboard wire harness B.
07sAz-T84011A
C o n n e c t t h e S R S i n f l a t o r s i m u l a t o r ( 2 Q
connectors) and simulator lead F to dashboard wire
h a r n e s s B .
Reconnect the battery negative cable.
Erase the DTC memory.
Read the DTC.
ls DTC 3-5 ind icated?
YES Go to step 15.
NO-Short to ground in the floor wire harness;
replace the floor wire harness.l
Turn the ignition switch OFF. Disconnect the
battery negative cable, and wait for 3 minutes.
' 1 1 .
1 4 .
I
23-53
16. Disconnectthe driver's airbag connector (see step
2 on page 23-211,lront passenger's airbag
connector (see step 3 on page 23-21), and front
passenger's seat belt tensioner connector (see step
5 on page 23-22).
17, Disconnect SRS unit connector A ('l8P) from the
SRS unit (see step 7 on page 23-221.
18. Disconnect the specialtoolfrom dashboard wire
harness B.
19. Check resistance between the No. 8 terminal of
SRS unit connector A (18P) and body ground, and
t h e N o . 1 7 t e r m i n a l a n d b o d y g r o u n d . T h e r e s h o u l d
be an open circuit, or at least 1 M Q .
SRS UNIT CONNECTOR A (18P)
ls the resistance as specified?
Y E S - F a u l t y S R S u n i u r e p l a c e t h e S R S u n i t { s e e
page 23-122l,.a
NO Short to ground in dashboard wire harness B;
r e p l a c e d a s h b o a r d w i r e h a r n e s s B . l