Honda EP3 Service Manual page 513

Driveline/Axle
Driveshafts Reassembly (cont'd)
Check the alignment of the paint mark (A) with the
o u t b o a r d j o i n t e n d ( B ) .
7. Pack the outboard joint (A)with the joint grease
included in the new ioint boot set.
Grease quantity
Outboard ioint: 105 115 g (3.7 4.1 ozl
/ r
llt ,)
\ { (
-*>
:;,"0'A?g.fff
:l:f
'., o "o
1 6 - 1 6
8. Adjust the length of the driveshafts to the figure
below, then adjust the boots to halfway between
full compression and full extension. Make sure the
ends of the boots seat in the grooves of the
driveshaft and joint.
Left driveshaft:497 502 mm (19.6 19.8in.)
Right driveshaft: 475 480 mm {18.7
t
-tTfi'.D.ilTD
1 8 . 9 i n . l
Fit the boot (A) ends onto the driveshaft (B) and
o u t b o a r d j o i n l ( C ) .
9 .
{