Defining Automatic Configuration Settings {Auto Configuration - Nomadix Access Gateway User Manual

To add an IP address (or range of IP addresses) to the list, enter the "starting" IP address in
6.
the Access Control Start IP
If you are adding a range of IP addresses to the access control list, you must now enter the
7.
"ending" IP address in the
address, enter
Click on the
8.
To remove an IP address (or range of IP addresses) from the list, enter the "starting" IP
9.
address in the
If you are removing a range of IP addresses from the access control list, you must now
enter the "ending" IP address in the
single IP address, enter
Click on the
10.
list.
If you enabled Access Control and have "locked yourself out," of the system
(for example, because you've forgotten your password), you must establish a
local serial connection with the CLI to disable the Access Control feature, or
change the range of allowed IP addresses to access the management interfaces.
If you have changed the serial port to act as a PMS interface, please contact
Nomadix technical support. In this case, refer to
page

Defining Automatic Configuration Settings {Auto Configuration}

The Access Gateway allows you to define parameters to enable the automatic configuration of
the system. See also,
70
field.
Access Control End IP
in the
None Access Control End IP
button to add the IP address (or range of IP addresses) to the list.
Add
Access Control Start IP
in the
None
button to remove the IP address (or range of IP addresses) from the
Remove
311.
RADIUS-driven Auto
field. If you are adding a single IP
field.
field.
Access Control End IP
Access Control End IP
Configuration.
A
CCESS
field. If you are removing a
field.
"Contact Information" on
System Administration
G
ATEWAY