Nomadix Access Gateway User Manual page 113

A G
CCESS ATEWAY
All IP addresses must be established, otherwise the Access Gateway will not be
"visible" on the network.
Make a selection for
6.
Gateway receives its IP address to work on the network.
If the Access Gateway receives its IP address from a

Nothing else needs to be configured.
If the Access Gateway receives a

Subnet Mask, and Gateway in the
If the Access Gateway receives its IP address from a

Configure PPPoE Client





Enter a valid subscriber IP address in the
7.
System Administration
Network Configuration Method
link and enter the following parameters:
PPPoE Service Name -
allowed length is 31 characters.
PPP Keep Alive
• Echo Request Interval in seconds -
echo requests from the NSE. The default value for this parameter is
30 seconds.
•
Maximum Missed Responses allowed -
echo-requests that can be allowed to go without a response before
the NSE determines that the PPP link is down. This parameter can
only set to whole number above 0.
PPP Authentication
•
Username -
required by your service provider.
• Password -
required by your service provider. Max length for both username
and password is 128 characters.
IP Configuration Mode -
the NSE. Setting this to Dynamic will obtain a dynamic IP address from
PPPoE server similar to DHCP client. Setting this to static will require
manually configuring IP address in the text box.
Maximum TCP MSS -
maximum value suggested by the RFC
. This determines how the Access
static IP address
Static Configuration Parameters
This is the Service-Name TAG. The maximum
This is the username for PPP based authentication
This is the password for PPP based authentication
This defines the IP address configuration mode for
Please note that this is the MSS not MTU. The
is 1452.
Subscriber IP Address
, select DHCP.
DHCP Server
, enter the static IP address,
box.
, select the
PPPoE Server
Setting this to 0 will disable
This is the number of
field.
101