Defining Automatic Configuration Settings {Auto Configuration - Nomadix Access Gateways User Manual

If you enabled Access Control, administrator access is restricted only to the IP addresses
shown under the "Currently Access is Permitted for IPs" listing. If you want to add to or
remove IP addresses from the list, go to Step 6 through Step 8.
The Access Control list can contain up to 50 (fifty) valid administrator IP
addresses or ranges of IP addresses.
To add an IP address (or range of IP addresses) to the list, enter the "starting" IP address in
6.
the Access Control Start IP
7. If you are adding a range of IP addresses to the access control list, you must now enter the
"ending" IP address in the
address, enter
Click on the
8.
To remove an IP address (or range of IP addresses) from the list, enter the "starting" IP
9.
address in the
If you are removing a range of IP addresses from the access control list, you must now
enter the "ending" IP address in the
single IP address, enter
Click on the
10.
list.
If you enabled Access Control and have "locked yourself out," of the system
(for example, because you've forgotten your password), you must establish a
local serial connection with the CLI to disable the Access Control feature, or
change the range of allowed IP addresses to access the management interfaces.
If you have changed the serial port to act as a PMS interface, please contact
Nomadix technical support. In this case, refer to
page

Defining Automatic Configuration Settings {Auto Configuration}

The Access Gateway allows you to define parameters to enable the automatic configuration of
the system. See also,
66
field.
Access Control End IP
in the
None Access Control End IP
button to add the IP address (or range of IP addresses) to the list.
Add
Access Control Start IP
in the
None
button to remove the IP address (or range of IP addresses) from the
Remove
297.
RADIUS-driven Auto
field. If you are adding a single IP
field.
field.
Access Control End IP
Access Control End IP
Configuration.
A
CCESS
field. If you are removing a
field.
"Contact Information" on
System Administration
G
ATEWAY