SHAFT DRIVE
g. If the ring-gear-to-thrust-washer clearance is
out of specification, select the correct thrust
washer as follows.
h. Select the suitable thrust washer from the fol-
lowing chart.
Thickness (mm)
i. Repeat the measurement steps until the
ring-gear-to-thrust-washer clearance is with-
in the specified limits.
Ring-gear-to-thrust-washer
clearance
0.2 mm
EAS00727
CHECKING THE DRIVE SHAFT
1. Check:
S drive shaft splines
Damage/wear ! Replace the drive shaft.
EAS00728
INSTALLING THE DRIVE SHAFT
1. Lubricate:
S drive shaft splines
Recommended lubricant
Molybdenum disulfide grease
2. Apply:
S sealant
(onto both final drive housing mating sur-
faces)
Yamaha bond No. 1215
90890-85505
3. Install:
S drive shaft
(to the final drive pinion gear)
6-87
CHAS
Thrust washer
1.2, 1.4, 1.6, 1.8, 2.0