Installing The Generator - Yamaha XVS1100(L) Service Manual

GENERATOR AND STARTER CLUTCH
4-51

INSTALLING THE GENERATOR

1. Install:
S starter clutch assembly
NOTE:
Align the hole a on the starter clutch housing
with the hole b on the rotor.
Starter clutch bolt:
12 Nm (1.2 mSkg)
LOCTITE
2. Install:
S timing drive gear 1
S springs 2
S dowel pins 3
NOTE:
S Align the punch mark a on the timing drive
gear with the key slide b .
S Push the projections c on the timing drive
gear into the space d .
3. Install:
S rotor assembly
NOTE:
S Insert the suitable pin 1 into the hole of timing
chain drive gear sprocket and match the gear
teeth.
S Align the punch mark a on the timing drive
gear 2 the punch mark b on the timing chain
drive gear sprocket and the key position c as
shown.
S When installing the rotor, make sure the wood-
ruff key is properly seated in the key way of the
crankshaft.
4. Tighten:
S nut (rotor) 1
NOTE:
Tighten the rotor nut 1 while holding the mag-
neto rotor with a sheave holder 2 .
Sheave holder:
90890-01701
ENG
175 Nm (17.5 mSkg)